1: Use a paper towel to wipe the nozzle
2: Use an air gun to blow the surface of the spray head
3: Raise the nozzle when the UV curing lamp is working, which will cause the UV light to shine on the nozzle, causing clogging
4: The UV curing lamp illuminates one side of the nozzle, and the installation of the UV lamp must not illuminate the nozzle
Five: Add inks from different manufacturers
Six: Plug and plug any plug of the machine electrically
7: To install any non-original parts, you need to inform the manufacturer's maintenance personnel in advance, and can only be installed and used after confirmation. For example, direct installation will cause equipment failure and charge maintenance will be charged.
Eight: Not connected to ground wire



